|
Structure and characteristics of the
The pump structure. New glume, structure, unique;Avoid the filling and thick
More difficult is not enough, make in a security side, high work rate.This machine
Main by electric machine, the worm screw speed, increasing pressure reduction, increasing pressure on the son, measurement
Pressure processing, material hopper, the electric control system and so on group, when used in the spray
, also including jet ejector, under its special points such as:
1, operating as a defence of simple, can rely on high, with imports
Device.
2, which gives simple and wheel type design, mobile party then.
3, can fill slurry liquid water-cement ratio around big, don't comfortable appropriate high consistency
The degree of labor demand thick.
4, can be note thick liquid liquid than the big grey sand, sand grain of grain diameter range
Wide;
5, and even to continue filling slurry, avoid the pump over large instantaneous
|
|
6, by dynamic pressure.When the slurry liquid filling, pressure force gathering
High, then to control and keep filling slurry pressure force.
7, after the slurry pressure reach to the design pressure forces, can turn the discharge
Because of the pressure.
8、With high pressure, large amount of flow meter, can be used in fast speed
Back to fill in the filling slurry, solid knot filling slurry and other engineering.
9、 配 合 空 压 机 和 喷 射 器 ， 可 进 行 作 业 面 表With air compressor and spray injector, industry can be made into line table
The surface of spray. 面 的 喷 护 。
Comfortable with van
This machine can be extensively used in road, rail road tunnel and city
Iron, chamber, such as under water electricity station to anchor solid filling slurry injection process and injection pressure force
Grouting engineering, but also to use in engineering bottom layer and the surface layer of outside wall
Spray to protect workers.
|
